The receiver for the BRICK and PAIL transmitters for connection inside electric panel.

Same model receiver can be used for all transmitters.

REMdevice radiocomandi radio remote control
It is simple to wire and install.

The receiver is produced using the latest technology and with a strengthened frame that makes it resistant to electrical and mechanical disturbances (like vibrations).

The DIN EN 50022 is designed for installation inside the electric panel of the operating machine.
REMdevice radiocomandi radio remote control
REMdevice radiocomandi radio remote control
The new radio module versions are made from components that guarantee stability of the radio frequency equal to 2 ppm (parts per million). In this way the remote control can be used in temperatures ranging from -20°C to +70°C (-4°F to +158°F) without needing to be calibrated.
MONITOR TESTER
The monitor tester instantly measures radio signal strength and disturbance levels in the working area of the remote control. It can also be used to see the channel and frequency on which the transmitter is programmed. It also provides the remote control’s settings and an accurate diagnostic readout.
REMdevice radiocomandi radio remote control
REMdevice radiocomandi radio remote control
TECHNICAL SPECIFICATIONS
 
  • Frequency: 869.700 - 870.000 MHz, 11 channels, 25 KHz
  • Frequency: 433.050 - 434.790 MHz, 59 channels, 25 KHz
  • Hamming Code > 4
  • Max no. of simultaneous on/off commands: 10 / 12
  • Command response time: 45 ms
  • Stop/Active emergency response time: 45 ms
  • Passive emergency response time: 1 s
  • Performance Level of safety function according to EN ISO 13849-1:2006
    • Stop protection: Category 3 PL d
    • Protection against unintended movements from the standstill position: Category 2 PL c
  • Range of control: approx. 100 m (~330 ft)
  • Working and storage temperature: -20°C to +70°C (-4°F to +158°F)

RECEIVER UNIT

  • Radio frequency Receiver: Single Chip
  • Antenna: ¼ λ amplified or directional
  • Power of command relay contacts: 4A (DC1/AC1)* / 115V
  • Power of stop relay contacts: 4A (DC1/AC1)* / 115V
    * connecting a diode in parallel with the load, the same current is allowed for category DC13 (inductive load).
    To comply with category AC15 is recommended to place in parallel connection with the load an appropriate overvoltage damping RC circuit. (Ref. IEC/EN60947)
  • Power supply: 10-30 Vdc / 24-48 V / 48-110 V
  • ModulBox casing for mounting on DIN EN 50022
    • Degree of protection: IP20
    • Dimensions: 158 × 90 × 75 mm (L×W×H) 6.22 × 3.54 × 2.95 in
       

 

The RxDIN receiver can be used with:

 

REMdevice radiocomandi radio remote control
REMdevice radiocomandi radio remote control
REMdevice radiocomandi radio remote control

TECHNICAL SPECIFICATIONS